Find a sheltered low-dust environment. Wetting the floor of your work area will also help control excess dust. Now we are ready to get started and install the Tint Kit in 4 simple steps:

**** When you Peel away the Pre Cut Window Tint pattern from the protective layer (STEP #2), do it very carefully. If the Tint catches at all,which is very rare, use a supplied razor blade to help it on its way. If you peel the tint cut too quickly and there is a catch, it could possible tear the tint. We are not responsible for the handling of tint after shipment. ****

1. Clean the glass

Fill the spray bottle with a half teaspoon of mild soap to each quart of water. Wash and dry both sides of window thoroughly. Do not wash and dry all the windows at once, just the one you want to apply window film to first. DO NOT USE AMONIA OF ANY KIND !!!!

Clean away excess debris on window by scraping lightly with the razor blade scraper. Use caution not to scratch the glass.

Wash and dry both sides of the window again until you are certain both surfaces are completely clean. Use care to clean all the way to the edges and into the corners around the window gasket.

2. Apply the Film

Identify the piece of window film that matches the window, Remember window film is installed on the inside of the window. Remove the clear backing on the film to expose the Tint adhesive, be careful not to crease or damage the film.

Wet both the adhesive surface of the film as well as the inside surface of the window with the same soapy solution.

Move the film into position inside the window, being careful not to let the film get creased or doubled over onto itself. The film should adhere to the glass fairly well with the soapy solution. You may want to temporarily tape the corners for added holding while you apply the tint to the glass. Spray the film once again with soapy solution.

3. Remove Excess Water

Use the squeegee to remove the soapy water and all bubbles from underneath the film while simultaneously smoothing the film onto the glass. Take your time and be careful and methodical for this step. Do not press so hard with your squeegee that you stretch the film. Remove bubbles by squeegee them gently to the edge and release them.

4. Remove Excess Film

Trim away any extra film hanging over the window edge using the razor blade. Be sure to be careful not to cut defroster lines on back windows

You are Finished!

Keep windows rolled up for at least three days to allow for full curing. The film may appear foggy, but this will clear up at the end of the curing process. Only use mild soap to clean window film, never use hard abrasives or chemicals.